| |
| |
>
FAQ´s Readers |
|
| |
|
|
| |
Questions:
1. L101: How
do I check for correct machine operation?
2. L101: How do I correct
the stamping quality?
3. L101: How does the
machine signal problems?
4. L70: How does the
machine signal problems during on-line operation while
scanning?
5. L70: How does the
machine signal the problems during on-line operation
for Badge reading?
6. L70: Are there emulations
that are compatible with these machines?
|
|
| |
|
|
| |
Answers:
1.
L101: How do I check for correct machine operation?
Switch on the reader. the following
occurs in the absence of anomalies when switching on
the reader :
The general switch light up.
The console LEDs light up for a few seconds.
The reader executes a document expulsion cycle to
the paper channel for documents.
that may have been left in the channel.
The console LEDs switch off.
[Return
to Questions] |
|
| |
|
|
| |
2.
L101: How do I correct the stamping quality?
When the quality of the stamp is no longer adequate,
increase the duration of contact time between inkpad
and paper to return to optimal stamping conditions.
Of course this is only possible when the inkpad has
not completely run out, in which case it must be replaced.
There are three possible variations on contact time.
[Return to
Questions] |
|
| |
|
|
| |
3.
L101: How does the machine signal problems?
If a problem is encountered while reading a badge
or document, this will be signaled by a pattern of
flashing LEDs, as shown in the following table. A
beeper sounds before the LEDs begin to flash if it
is activated by software.
[Return to
Questions]
|
|
| |
|
|
| |
4.
L70: How does the machine signal the problems during
on-line operation during document scanning?
Insert the document in the reader with the CODE LINE
turned as indicated on page 4 of the user guide. Now
the document is read and it is sent to the collection
channel for outgoing documents. The L70 Reader decodes
the CODE LINE sending data to the PC.
_ If during this operation the LED flashes and an
audible “beep is emitted, then one or more characters
from the CODELINE have not been decoded properly.
_ If a paper jam occurs, the LED flashes slowly 3
times and the beeper is sounded. Remove the paper
from the path and restart the scan.
[Return to
Questions]
|
|
| |
|
|
| |
5.
L70: How does the machine signal problems during on-line
operation for badge reading?
_ Insert the badge in the guide, with the magnetic
stripe opposite you and facing the notch.
_ Pull the badge through the reader from right to
left or left to right until it exits the other end
of the guide
_ The L70 Reader decodes the MAGNETIC STRIPE sending
data to PC
_ If during this operation the LED flashes and an
audible “beep” is emitted, it means the
reader is not able to read the MAGNETIC STRIPE.
[Return to
Questions] |
|
| |
|
|
| |
6.
L70: Are there any emulations compatible with this machine?
In order to manage the software packages which already
exist, the following emulations have been developed:
_ LG15 COMPLETE LINK
STANDARD LINK
CTS
SEMI SIMPLE LINK
SIMPLIFIED LINK
_ ZEISER
_ UNISYS EF 4592
_ KEYBOARD EMULATION
[Return to
Questions] |
|
| |
|
|
 |
|
|
